How to Pair the Remote Controller With the EVO Nano Drone

EVO Nano Series Drone Remote Controller Pairing

The remote controller and the aircraft have been paired in the factory. If the remote controller needs to be paired again after replacement, please follow these steps:

Method 1 (by Autel Sky App)

1. Turn on the aircraft and the remote controller, double-click the aircraft battery button. The LED on the rear of the aircraft will flash quickly to show it is ready to pair.

2. Connect your remote controller and mobile phone, operate Autel Sky App, click “Connect New Aircraft” in “Personal Center,” and follow the pairing instruction.

3. After successful pairing, the LED at the tail of aircraft will be on for 5 seconds and then flash slowly. The App will switch to the image transmission interface.

Method 2

1. Turn on the aircraft, double-click the aircraft battery button. The LED on the rear of the aircraft will flash quickly to show it is ready to pair.

2. Press and hold the power button and the home button on the remote controller at the same time for 3 seconds to turn on the remote controller. The remote controller indicator will flash quickly to show it is ready to pair.

3. After successful pairing, the LED at the tail of aircraft will be on for 5 seconds and then flash slowly.

Important

  1. In the case of frequency pairing, the aircraft shall maintain within 0.5m from remote controller.
  2. If a new remote controller successfully pairs its frequency with the aircraft, then the old remote controller will not be connected with the aircraft.
  3. If your mobile phone is disconnected from the remote controller in the case of pairing, please reconnect them within 60s.